Jump to content
HWBOT Community Forums
Sign in to follow this  
subaruwrc

Bullant - Phenom II X4 960T BE @ 6140MHz - 787 cb Cinebench - R15

Recommended Posts

do you have cold bug issue after 1 or 2 ln² session with your chip ? after 1 or 2 session with my chip i can't go fullpot but don't know why !

Share this post


Link to post
Share on other sites
34 minutes ago, Radi said:

do you have cold bug issue after 1 or 2 ln² session with your chip ? after 1 or 2 session with my chip i can't go fullpot but don't know why !

Are you sure it's the chip and not the board? I had a sabertooth devolop a -80c cbb but the same cpus fullpotted fine on other boards.

Share this post


Link to post
Share on other sites
9 hours ago, Radi said:

do you have cold bug issue after 1 or 2 ln² session with your chip ? after 1 or 2 session with my chip i can't go fullpot but don't know why !

Hey mate, yeah for me I have cb if I push memory freq "imc" to high, or have to high nb-CPU volts, you know the volts we use for nb freq.

 

So yeah if you have cb that can start at around -160 to -170 try lowering memory freq a little or try set lower nb-CPU volt the one we use for nb freq, normally once you get it full pot you can then push memory, nb freq and nb-CPU volts 

 

with this chip chip and psc I had problems to start with also, so I was 2160 mem with cb -165 had to drop mem to 2000 and cb went to -180....once I was full pot I could then push 

 

all my chips do it, just some are worse then others and normally lower nb-CPU volt alows me to go full pot, then can smash volts.....,also start with lower nb freq just to get full pot 

 

 

46 minutes ago, l0ud_sil3nc3 said:

Damn that ram freq!

 

Well done Bully.

Hey mate, yeah it'll do 2200 6-8-6-21......but with 5 lrts and trying to work CPU max out, thought not good idea to push memory lol

 

Great to see you around mate 

Edited by Bullant
  • Thanks 1

Share this post


Link to post
Share on other sites
10 minutes ago, Radi said:

many thanks !! i will retry soon !

Great, hope it all goes well mate....I'll try rerun myself in couple weeks 

Share this post


Link to post
Share on other sites
8 hours ago, unityofsaints said:

Any particular reason you used the UD5 instead of UD7 here? Epic result!

No reason really, I just wanted to try the ud5.....I say the ud7 would do ok too. I'll run this chip again on this and may try the ud7 as well 

  • Thanks 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×