Jump to content
HWBOT Community Forums
chispy

Single Stage Service/Repair in the USA

Recommended Posts

 I have a very small SS unit Mach 2 that was tuned and performing amazingly good ( 3D on 9900k @ 5965Mhz load no HT ). But after benching my i3 7530K for 8 hours one night it lost the performance and now it wont hold any loads at all :(  . It idles at -32 but it cannot hold any loads at all and it will crash when running my cpus :( , I’m very sad since LN2 it's very expensive here on the Island of Puerto Rico and the Dry Ice plant its an 8 hour drive round trip , so my real choice are Single Stages , Cascades and water chillers.

 Anyone knows who can service/repair this little tinny unit ? it s an old Mach 2 was tuned and regas long time ago to hold 300w loads. I need some help with this ss , i will really appreciate any help , guidance or tip on this matter. Thanks in advanced.

 

Kind Regards: Chispy

Share this post


Link to post
Share on other sites

I have a ID Cooling single phase change cooler full size pc case that I am selling for inexpesive. You may end up paying a few hundred to try to get these such units repaired by someone. I would say a a mininmum of 200 at least it will cost. I had my phase changer on my i9-9900k stable 5.6 all core under load with it not scrapping even close to 60 celsuis

 

  • Like 1

Share this post


Link to post
Share on other sites

Thank you for the offer , i already have a new SS coming and my old one will be serviced/repair soon.

Kind Regards: Angelo

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...