Hello all,
I'm trying to see how much i can overclock this ram kit i have which to be honest it probably didnt have much potential from the start since it is a 3200C16 - 32GB.
Dram calculator(only used it to check bin quality - not using its output for setting the timings) shows a 81% bin quality so im not sure if i am to take this with a grain of salt.I just think this is one of the low end b-dies.
However, in order to see if i can hit 3600, i set docp to manual, set all timings to auto and put 1.45v on dram and soc at 1.15v. That would result in no boot.
However, changing main timings to 22-22-22-25 and at 1.46v it booted but then crashed at windows. This didnt change with either 1.47v/1.48v/1.49v so i decided to stop there since i guess i would have to overkill it with voltage just to do 3600 with ridiculously high timings.3533mhz is achievable with quite high timings and stable results at windows so i went further down to 3466 and this is where i am now trying to tighten timings.
Dram voltage is at 1.3950 and SoC at 1.125.
Changing down trdrdscl and twrwrscl to 3(instead of current 4) results in either crash/reboot or bluescreen/freeze. changing trtp down to 8 from 10 system hangs and have to clear cmos.
For TRFC ive only tried 512(current value 560) but pc doesnt boot and have to clear cmos so i;m guessing i must be quite close to its limit if not already there.
Trp can go down to 18(current is 19) but i get errors on stress test(same voltages).
Tras lower than 62 crashes/reboots pc(same voltages)
I'm not sure if theres any point trying for tighter timings.
Any advice/recommendations would be much appreciated