Overclocking my EVGA GTX 690 Hydro Copper

[Martsmac]

So I'm re-writing this post as I started from scratch so as to get a completely stable and high OC.

 

So by increasing just 1 of the clocks in 10Mhz increments at a time and then running haven, valley AND 3DMark 2013 I have so far gotten my card to the following settings (It is rock solid running Firestrike completely maxed out for over 2 hours without crashes or artifacts)

 

GPUClock Speed : 1202Mhz

GPU Mem Speed: 3121 (which when doubled as its GDDR5 is 6242Mhz)

Voltage : 1050mV

GPU Offset: +160Mhz

Mem Offset: +120Mhz

 

Temps: GPU1 43 C max under full load

GPU2 45 C max under full load

 

Power Target: 135%

 

So far I'm pretty happy with these results, having said that I'm relatively new to OC'ing GPU's so I have no idea if this is actually a good overclock or not. Also I feel this card has quite a bit more room to OC , but it would invlove raising the voltages even more, I'm sure I'll get around to it later. Thoughts guys (and gals)????

 

Thanks

 

Martin

 

P.S. Now I'm going to "real world" test it with some Crysis 3.

Edited July 25, 2013 by Martsmac
Re-wrote post.