Castle

Yes Fredyama's 3866 profile does work, the only change I had to make was setting IO and SA voltage both from AUTO to 1.25 volts. Dram voltage is at 1.90 volts which is what the profile sets it to. All the timings in the 3866 profile worked perfectly. But what does that mean in relation to trying to get 4133 C12 to work ? I have read all your DDR4 guides that you have written, which has helped me learn how to overclock b-die, but the codes 49 and 2b are not covered in your guides as to what they could be referring to and what to change, which is why I am not sure what to fix in order for it to work successfully at 4133.

When overclocking b-die memory on an Asus Z270 Apex board with tight timings of 12-11-11-28-220-1T at speeds of either 4000 or 4133mhz, what does it mean when upon memory training and boot up, it gets a code of 49 followed by a code of 2b on the LED display on the board? Is it a problem with timings, or RTL/IOLS or voltages ?

There is no registration time, just the date. But what is it that you are trying to ascertain ? What does the registration time have to do with not being able to post in any threads and not having any PM options in my account ? Is anyone please able to PM a moderator or administrator and ask them to please look into my account and fix whatever is wrong with it. That would be greatly appreciated. Thankyou.

On the Z270 Apex, when trying to overclock to 4133 C12, what does it mean when it gets a qcode of 49 for about 5-10 seconds, followed by a qcode of 2b and then it stays on 2b until you reset the board or use the safe button?

It only shows a join date of 07-20-2017. No time, just a date.

I don't know what time it was registered, where do I find that out from ?

Hi, I am unable to post in any threads and have no private messaging options at all, to be able to send or receive messages. I read through the support section and my profile is missing all the above. Can someone please fix my profile so it is working properly. Thank you.

I have been reading all your guides on DDR4 memory overclocking and I have the Trident Z 3600 C17 Kit and an Apex motherboard. I am trying to overclock to 4133mhz C12 and am getting the qcode 49, which stays on there for about 5-10 seconds and then it changes qcode 2b and then stays at that code until I either power off the board or press the safe mode button. Could you please tell me what those codes mean as they are not in the Apex manual and what would I need to adjust in my memory timings to overcome those two codes and get it to boot up? Thanks.