MetalRacer

January 3, 2019

Would be nice to see Heaven Extreme and Superposition added to the mix.

January 3, 2019

December 30, 2018

Agreed HWB has no responsibility for monetary loss but they could ban the party guilty of bad behavior. In my case someone fairly well known ( strong island ) and thought to be trust worthy has been stringing me along for six months. After the last communication below he just ignores PM's yet he has a new for sale thread @OCN.

https://www.overclock.net/forum/14786-full-systems/1714412-fs-high-end-r6-1080ti-i7-8086-build-hard-tube.html

December 29, 2018

Would be nice to see some type of recourse taken against the swindlers such as such as HWBOT accounts banned and all submissions removed.

December 28, 2018

Well done!

December 27, 2018

I think 4.28 is the newest for your version of xp.

https://benchmarks.ul.com/systeminfo#sysinfo428

December 22, 2018

Heaven deserves consideration for sure.

December 15, 2018

Delid and replace TIM.

December 3, 2018

December 2, 2018

Nice 1!

November 30, 2018

November 28, 2018

November 17, 2018

Killer!

November 15, 2018

3 hours ago, MaddMutt said:

I have a question that has not been answered by KPC yet. I do not feel that it's their fault as they must first either get the board and verify a problem or ask several owners to verify if there is a problem.

I currently own 2 ASRock Z170 OCF motherboards and have one setup for Dice benching. I purchased the motherboards during the Team Competition 2018 a few months ago. The Motherboards are Rev 1.03. I have a problem with mounting my older KPC F1 Dark and I hope someone else has been able to find a simple solution.

I installed the F1 Dark for my benching of my i3-6320 for the Team Cup. While installing the Back Plate/Rods through the mounting holes, it did not want to line up. The back plate did not slide smoothly during installation nor sit flush with the motherboard. I had the feeling that if I tightened the screws on the Hold Down Plate that I would crack or break the motherboard.

I would gladly buy the "New Mounting Hardware" at KPC if this would solve my problem. Other than the AM4 compatibility, it looks identical to the one I have.

Is it just me being to cautious on properly mounting my F1??

Would it be easier to just purchased a New Cooler from KPC??

Thank You For Your Time And Assistance

This is the proper orientation for the back plate/rods.

http://forum.kingpincooling.com/showthread.php?t=488