I am likely going to be RMAing this board, it doesn't actually work in tri-channel mode. 6 GB is recognized occasionally in BIOS, but only every once in a while...I tried the two sets of RAM I have here, I tried my initial three sets (OCZ XMP, these Super Talents and some generic DDR3 from a dell) and swapped my CPU for my i7-920.
That would be fine, except that I just received this board back from six months of pending RMAs, five RMAs deep is not a nice place to be, especially when they send you two boards that do not post. One of which has a back-plate from the Apoggee GT stuck to its underside (who uses epoxy/superglue to place a backplate? Or else who raised the temperature of the rear of the socket enough to make some solder reflow ).
I will be making a dice pot in my school's machine shop in a while, though I will likely post a number of simulations of the pot in SolidWorks before hand, assuming I can get it to work the way I want it
I may end up using Inventor, as much as my school does not support AutoDesk products .