Jump to content
HWBOT Community Forums

Niuulh

Members
 View Profile  See their activity

  • Posts

    187

  • Joined

  • Last visited

 Content Type 

Posts posted by Niuulh

    Rampage V Edition 10

    in Haswell-E (X99) OC

    Posted

    Is the MEI driver installed according to the device manager? Did you try installing all the services in the sub folders of the TurboV Core installation package? Did you disable any Asus services?

     

    Z170 also on XP? It sounds like you have incorrect speedstep/turbo mode/c-states settings.

     

    What do you mean with x99ratio fail in loop?

     

    I make a screen with all info if that can help.

    Rampage V Edition 10

    in Haswell-E (X99) OC

    Posted

    Yes. With Fully Manual Mode = Disabled all voltage control is through the FIVR. With Fully Manual Mode = Enabled there's a few additional tricks applied which is interfering with the per-core voltage adjustments.

     

    Thanks :)

     

    Do you have a solution for benching on XP ?

    I can't install the MEI and can't clock :S

    Reference RX480 support

    in EVC Support

    Posted

    Ok, fixed bios here:atiflash rx480 ln2. Run the approperiate .bat file as administrator to flash your card.

     

    ASUSRX480.air

    • Increased power limit to 150W (225W with +50%)
    • GPU Voltage adjustment up to 1.4V in GPUTweakII

    ASUSRX480.ln2

    • Increased power limit to 150W (225W with +50%)
    • Current and power reporting is half so power limit is actually up to 450W
    • GPU Voltage adjustment up to 2.0V in GPUTweakII
    • Fixed clock frequency at all times
    • Fixed at PCIE 3.0 at all times
    • Thermal reporting disabled (cold slow fix), be very careful and make sure you have good cooling for the GPU since there's no over temperature protection any more.

     

    On the card I tested I had coldbug at -155*C, but it works fine above that even cold boot. It's a bit similar to GTX1080 when it comes to voltage and doesn't seem to like much more than 1.3-1.4V. I could run higher but it didn't gain me any frequency. For example I don't get display output if I try to POST with above 1.3V. The biggest obstacle is however the Crimson driver which saves your clock frequency each time you set it (even from GPUTweakII) which means you'll be booting with high frequencies. I could go into the OS with 1.3V set using eVc at 1700MHz core which helped a lot when benching this card. Similarly as with POST I would lose the display output if I tried to enter the os with above 1.3V.

     

     

     

    It's just a test on ln2 to check issues etc. I'll leave the proper scores to you guys.

     

     

     

    Thanks man.

     

    Hi, thoses bios can work on my Nitro+ Saphire or it's only for Ref boards ?

×
×
  • Create New...