Johan45

Thanks, that's reasonable. They have always been lax on drivers IMO

So we pay cause UL can't do their damn job, awesome!

For the Night Raid submission, it says valid UL link. Is unapproved driver an allowed exception? I don't understand why the driver for my board which has been up since August hasn't been tested/approved, it's an official driver, not a beta.

Thanks Flank3r

That's good to know!

Thanks for the clarification Leeghoofd

That's why I want some clarification, just because it took the GPU and not the CPU doesn't mean the filter is correct. It appeared you were having issues right from the beginning. If you check the 3Dmark tests it specifies GPUs in the limitations, I think they would do the same for GPUPI if it was intended to be run on a GPU. Seems counterproductive since the Division is for Ryzen CPU, not video cards.

That's not the way I read it. Under limitations, it specifies all the ADM CPUs you can use not GFX cards.

Are we running this on the CPU or GPU. I assumed the CPU since we already have two graphics tests in the division and it is for Ryzen but the first submission I see is for GPU which was unexpected. I see in the discussion the poster thought it was for CPU as well but the engine wouldn't take it. Just looking for clarification

Thanks. I notice that the unlocked shareds still hasn't been fixed. I posted that months ago

Is that enough verification ?

Thanks FLANK3R

9 times out of 10 ES suck to begin with

Sweet jeebus this is getting really lame

Do we really need all those tabs open or just what's required by the rules?

That sucks Marc. Tracking is not a huge expense and the whole transaction does sound a bit suspect. I wouldn't be surprised if this is the end of it already. Like bassplayer says I've seen people go bad before like flicking a switch.

The turboV seemed to work properly, didn't notice any weird settings but as soon as I used it then GB and GPUPI would fail at known good settings. Cinebench 11.5 and 15 worked fine using TurboV

All from BIOS, It would boot at 5200. Using TurboV would cause Geekbench to crash, took me a bit to figure that one out

Thanks

I was lucky this one didn't mind a bit faster memory

Thanks Marc that was quick

I was so close to #1 ended with a water problem

You worry too much, auto works fine so does LLC 3 you just need to set V_Core to accommodate your needs. Auto will have a larger droop under load. I never had issue with that until I pushed harder and the droop started to increase. Then I raised it to LLC 3 which kept load voltage ~ .025V lower than BIOS setting under load.

That could make all the difference just don't expect those speeds. timings yes but the IMC is kinda cold sensitive as I said earlier but it's very CPU dependent, some are better than others.

Stock DDR is G.Skill 3600 Cl17-18-18 from December 2015. The PCIe bus drops to Gen2 automatically and will drop to Gen 1 but I'm not at that threshold. It will affect transfer speeds but not that badly besides you're not likely doing 3D benchmarks on this platform any way