Seby Posted July 2 Posted July 2 Lock up/shutdown or BSOD? Have you tried VCCIN 2.3-2.7 if the former, or easy memory settings like 7200 if the latter? Quote
ShaggySVK Posted July 2 Posted July 2 @george FLL was set to ratio OC, @seby Lockups only, no BSOD or shutdown, VCCIN only tried between 1.8 and 2.1v (seemed like it was getting worse with more, though might have been condensation at that point 1 Quote
Seby Posted July 2 Posted July 2 Can also try really low SA like 1.1, or Doomed says his chips need high SA like 1.35+, but it really should be pretty easy, especially if other board did it fine Quote
ShaggySVK Posted July 2 Posted July 2 SA didnt seem to really help if i added over 1.4v from 1.25 being sweetspot for cascade(-100c), will try dropping below 1.2v and see if that gains me anything. Oh low mem clocks including JEDEC havent influenced the CB. Quote
ShaggySVK Posted July 2 Posted July 2 only thing that seemed to drop the CB a little was IVR TX, that got me from -165 to around -180c but very unreliable Quote
l0ud_sil3nc3 Posted July 2 Author Posted July 2 @ShaggySVK maybe just need @Hiwa to use that plastic straw and "brush" some more vaseline in the socket, what could go wrong? In all honesty did you get the board all cleaned up? Quote
ShaggySVK Posted July 2 Posted July 2 Dude, I spent half a day rewashing that board and its still somehow a regenerating new layer of vas on surface everytime you heat it up :D Quote
ShaggySVK Posted July 2 Posted July 2 socket and mem slots are all mint, washed those out multiple times with contact cleaner, no residues there. Quote
Dr.Antoine Posted July 2 Posted July 2 find harder to full pot with encore than white maybe due to new bios try to go back to previous bios or use mode 2 with ln2 mode enable and load preset too, keep in mind that ivr increase around 0.1v compare to ambiant and sa same Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.