Gluvocio Posted April 26, 2012 Share Posted April 26, 2012 perhaps you have a wall on MCH or NB or CPU Have you tested it with different cpu ? What's your mainboard FSB edge ? Wat's your memory edge on that main ? You did much job for small benefits... Pcmark on LN2 should make a person very busy doing it. Quote Link to comment Share on other sites More sharing options...
Mafio Posted April 26, 2012 Share Posted April 26, 2012 third place is still good, congrats. Quote Link to comment Share on other sites More sharing options...
SteveRo Posted April 26, 2012 Share Posted April 26, 2012 ^^ Denis - thanks, all good ideas - yes, I need to isolate the problem - could be the board or the cpu I guess. I do have other cpus I can use to test the board. Thanks Mafio - was already at #3 trying to improve! Quote Link to comment Share on other sites More sharing options...
mr.paco Posted April 26, 2012 Share Posted April 26, 2012 May just be the chip is a slacker . Do you have another 145 to try in that same set up to test? But as always, still a great run... Quote Link to comment Share on other sites More sharing options...
BeepBeep2 Posted April 26, 2012 Share Posted April 26, 2012 I think HT Ref. is really limited to the individual motherboard/chip and there isn't much to do for it. You can try to put HTT and CPU_NB voltage through the roof but I don't know if that will help. I really like the board though, I had one of those, back in 2010 and sold it to Gautam...is that the one I had? Quote Link to comment Share on other sites More sharing options...
Crew Don_Dan Posted April 26, 2012 Crew Share Posted April 26, 2012 I don't think this is your board Beep! Quote Link to comment Share on other sites More sharing options...
BeepBeep2 Posted April 27, 2012 Share Posted April 27, 2012 I wouldn't either Might as well ask! Quote Link to comment Share on other sites More sharing options...
SteveRo Posted April 27, 2012 Share Posted April 27, 2012 Beep - na - i bot this boad new. at sompoint i will try a different chip in it - see if the bus spped wall is the board or the chip I killed my last sempron with too much cpu/nb - would like to not do that again!! Quote Link to comment Share on other sites More sharing options...
I.M.O.G. Posted April 27, 2012 Share Posted April 27, 2012 My chip ran out of gas around there I think Steve. I thought it was the mainboard, but then I switched to a board that can do known higher FSB, and it didn't go any further. Don't feel bad about killing Sempy's. They are cheap and easily replaced... Reminds the chips who is boss. Good job. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.