Jump to content
HWBOT Community Forums

Recommended Posts

Posted (edited)

KPC Ney Pro Mem Cooler How to go sub -100c

JHVIplw.jpg

 

A couple people have asked me why the ney pro is only good up to around -80c to -90c. So here is a guide to hit crazy cold numbers using the ney pro.

 

First off get rid of your stock heatspreaders. It doesnt matter how "good" or "heavy" they are, (I will say the dom GT are okay) they are not optimal for benching cold.

Heat them with a hot air gun or hair dryer for a minute and they will come off easy everytime.

JNFW8O7.jpg

 

 

Measure from middle of slot A1 to middle of slot A2 (asrock z87 formula is 19mm)It will probably vary slightly by manufacturer. Mark this in permananent marker on the pot trying to center it best you can. You dont have to get too anal here.

nnT2CEZ.jpg

 

 

Next get some good quality tape and slap it on the insides of the spreaders. I suggest something sticky and thin as possible as it will hold the dimm while mounting even before you screw it in, and thin because large pads tend to crack under extreme cold.

e6k2cI2.jpg

 

 

 

trim the excess with a razor.

Uxs9quI.jpg

 

 

 

trimmed up and peeled read to receive the dimms.

kfxzCas.jpg

 

 

 

so you are going to go ahead and stick the dimm to the skinny side first

7TMiS2F.jpg

 

 

 

backside view

Pnd8EP5.jpg

 

 

 

this is a very important step, you want to tim the top of this skinny peice before you join it to the fat piece.

Dxbij55.jpg

 

 

 

Joing the skinny and the fat. things get a bit messy but just have some paper towel on stand by

M8xv7tT.jpg

 

 

 

cleaned up

F0dzJDA.jpg

 

 

Now more tim. This time on top of that fat rail. This will be between the pot and spreaders so be generous.

ZksUnL5.jpg

 

 

 

place the mounted dim on the pot and aim for your little dashes. If not perfect just shove it over a bit.

voigrkE.jpg

 

 

 

And finally tighten down the screws when you are lined up with your dashes.

ymFT408.jpg

 

Repeate on the other side.

 

 

Last part is placing your probe. Best spot to do this is shown. I like to thread it through the pot side hole twice so if I snag the chord it wont pull prob loose in the middle of a session.

I like to put it on the inside side and try to push it 1/4 or more inside the spreaders (under the tape).

78rBMgv.jpg

 

 

 

Pot should now be good up to -150 to -160 depending on ambient and other weather factors.

Edited by Splave

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...