Posted September 30, 20168 yr Hi ! Here we can share all tricks we found about this table This is my fixations tricks for mITX Vapor extraction and AIO on the table to take advantage of free space
October 11, 20168 yr Nice dual rad setup. With the space at the bottom of the mono maybe some space to fix the Pump ?
October 12, 20168 yr Author Sure, but i'm using submersible pump. I'll got watercolling pump later, i'll update with full loop on the table
October 25, 20168 yr Author When using a too lenght graphic card and have a rad mounted on the right side, you can use motherboard standof.
October 25, 20168 yr Wooh ! The Niuulh trick magic again ! I would not do this with the table being with the feet's, it would put way too much pressure on the threading of the stand off.
October 26, 20168 yr Crew Haha, nice trick. As trouffman said, be careful with the weight of your rad. The standoffs are made of steel, so they should be fairly solid - still we do not recommend doing that too much ...
November 21, 20168 yr You are so creative with this ! Once you have access to a 3D printer this will go nuts...
November 22, 20168 yr Author I really wait for 3D printer ! The thing what i need the most is a 90° adapter for screws and a loooooooooot a spare to build higher !
November 28, 20168 yr Crew Ahahhaha we definitely need to make some moder awards for the table! You would get the "Crazy Mod" award ^^ BTW we received a whole box of spare parts that we ordered from the factory (spare thumbscrews, standoffs and brackets). Will configure the shot to have these available end of next week.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.