no freq limitation for this division?

Not intended... If you all want I can put 4503mhz?

As you prefer...I just noticed this is the only division without freq limitation

Is x99 ok for this one?

No it's 2011 not 2011v3... No ddr4 here

this has probably been discussed before, but I want to make sure I understand this right.

"Processor must be idle/load and at positive temperatures (HWinfo v6.+, OHM readout)"

Positive temps as in +20*C ambient or can I put the radiator out the window where it's around 0*C and HWinfo would still show positive temps?

Thank you.

if hwinfo gives positive temps it is accepted.... 

If i can do idle with +1 degrees it is okay thats right?

yes it's a positive temp Frank

!!!!!Due to multiplier detection error , Open Hardware Monitor will no longer be allowed for future submissions. Frequency (and temperature) Monitoring via HWinfo32/64 and or Benchmate!!!

Please add Asus P9D-X to DB.

From my subs https://hwbot.org/submission/4364115

On 2/26/2020 at 11:28 PM, phantom.ololo said:

Please add Asus P9D-X to DB.

From my subs https://hwbot.org/submission/4364115

added

All scores are moderated, putting up a bunch of posts at HWBot's Facebook page, if you see your setup pass by, plz tag !!!

New here.

so an x5675 intel is OK but not a gtx950, is that correct?

yes sorry , for the old legacy patforms we also impose a GPU limitation, community opted to go for maximum a GTX770 for nVIDIA users

I see a lot of subs with HWinfo running, but not showing the info me and the rest of the moderators require

You can adjust the looks of HWinfo by either pressing the configuration cogwheel tab or by a right mouse click (on the opened HWInfo) and selecting the layout settings

This will after hiding a lot of  HWBot invaluable information (in my case up to 227 settings hidden) result in a smaller HWInfo window