3D01 is ultra tweakable, in this case make sure the CL is high enough. You can adjust nature later on till you get close to 999.9
Try to get the ram as tight as possible ( via memtweakit ) 3D01 is very sensitive to it. Don't even think of running single channel... I would carefully remove the heatspreader of the dimms...
Also is the legacy benchmark setting enabled in the ASUS bios ?
Chill dude, it just the way it is, some will never see it, that there's more to it then just raw clocks...
No need to get arroused, that's my job
Which submissions is he referring too ?
Plz tell us what the problem is :
1) You cannot stabilise the ram at 2400MHz
and/or
2) You set 2400MHz, but the board boots at 2200MHz
3) ...
I'm getting completely lost here what exactly is going on... Has something been solved or are the numerous issues starting from post 1 still present...
I would switch back to the ASUS board if your current hardware runs on that... check timings and co what the ASUS sets and try them timings on the UD4H