Broken APEX49

Hello. Based on the information you gave me, I will change the DRAM voltage to 1.95 V and the VTT voltage to half. When I adjusted the IO and SA voltage to 3.0 V and turned it around, the result was very good. However, I am confused because I feel that some of the timing is different from the BIOS information of ASUS even though I input the timing according to the information you gave me.

I'd like to explain conversantly later.

I'm sorry to have little information for certain. I'll attach the data which was being carried out until just now.

Super Pi, when it drops in E - RAM, and I make them start, and 16K is carried out once, is it effective in 32M after it?

Hello Thank you very much for your advice. Are IO and SA too high in voltage? The DRAM voltage, 1.9-coordination? MAXMEM was set in 600. The memory I'm using? It's GALAX HOF OC Lab Master DDR4-4000. It isn't also waza ari, but the situation doesn't change.

In Windows XP. The adjustment of MAXMEM is inexperienced. I thought if it was cut with a boot, OS was unnecessary.

You could get Windows XP. SuperPi 32M is being carried out after a long time. CPU 9900KS M/B Z390 APEX Memory 4000-4133 12-12-28-1 IO 1.45V SA 1.4 By a little information, thank you very much. OS can be started with no problem. When SuperPi 32M is carried out, 1 loop can't also be carried out. Even 1.98-2.06 adjusts the DRAM voltage. IO and the SA voltage are also adjusted between 1.4-1.45. But the situation doesn't change at all. I don't know what is a problem. A memory, the execution of SuperPi 32M is no problem by XMP movement for itself. 5.0 voltage is 1.3V and CPU is fixed.

It could be understood! I thank. Thank you very much.

Where is its location? You can't arrive in an edit screen.

How is my result? Because there is no data which becomes reference. I'm learning by trial and error. Please advise by all means.

Mr. keeph8n Thank you very much for your answer. Could you tell me a way of the edit?

Please tell me an input method of the item of the cooling when uploading a record in BenchMate 0.10.7.

Corrected below

Everyone, hello. I'd like to challenge SuperPI 32M in Ryzen, too. A problem wonders about whether possessed 3600XT can reach 5G. When whether it's invalid does multi-threading, shall the one I can reach go out?

It was set as ln2mode today, I think is high. Don't I have to drop some voltage?

You want a picture of a screen shot in detail, right?

It was study very much. Thank you very much.

The one with the bad score of R0 stepping? I knew for the first time.

The one with the bad score of R0 stepping? Will there be also no room of improvement from now on?

PiFast is also the same situation. Is 8 the influence by which this is also R0 stepping?

I see. It was understood.

It's wPrime in the bench Mate to the end, but under 4 core restriction and the 5.5G restriction? The 8700K, that the score is better than 9900K? The-> time when the score is good is short. Only my problem?

Use method of AKURONISU, it can be understood, without, the introduction by which I'm WindowsXP, it isn't done yet. The introduction which are E - RAM and a waza folder even if it can be introduced, is also the unknown world.

give up

Why is the score of 9900KS lower than the score of 8700K? Is there a problem just for me? It ’s inside the benchmate.