zeropluszero

I cant seem to get a reading on the points noted for the VR points noted on the picture from TL, do I need to power on the card to get a reading (so I know what size VR to solder on) or can someone tell me what I need? muchas gracias

MFW my personal best is under 15K

Looking for older model epower. Posted to Melbourne Australia.

These legacy scores you're getting are incredible.

thats nice man! Ive just plastidip sprayed 3 boards, but between the memory slots I've just been putting down toilet paper between slots.

Easy peasy. Will do. Thanks.

Managed to get a hold of a power min card, mines come with three wires soldered to the right most end of the pcb Now i understand that i solder the left most side over the chokes im replacing like an epower mod, but is the right most side where i input power from psu? Is it best just to solder on a fan connector like this one? TL posted this guide on control here

swag on fleek, i cant even

Thanks Dino. I promise one day to get around to that videocard bit. Someone else can feel free to do a memory prep guide, I wouldnt say I know what I'm doing there.

Hardline here haha

This is going to be great.

Thanks!

At least dust doesn't stick to it.

ouch if anyone has samsung i'd be interested to know what their default voltage is.

No idea. Im not intending to remove it.

Samsung or hynix there?

Thanks Coolice

Ah ok, no problems. Ill find someone who has a 780 to check with about the memory voltage, or just start low.

Some clarification on the between the memory slot stuff. freshly plastidip'd motherboard. single sheets of toilet paper, cut in thirds. then fold each of these in half twice jam them down in unused slots and between them. this area is prone to condensation and is difficult to vas. I use a butter knife, and these are easily removed with tweezers. hey presto

Can I ask what the resistor does? Can anyone tell me what the default memory voltage is? Thanks, I'd assumed it was those chokes but wasn't 100% on it

Have here a GTX780 ref with samsung mem, same PCB as Titan here http://forum.hwbot.org/showthread.php?t=93515 Have busted the memory mod, and I'd like to epower the mem, can someone help me out as to where I need to solder it to? Ive already had the chokes cut off for epower to the core, and I have a dual channel black epower here I can use, just need to know where I need to solder it to.

If you have the screens just resubmit it. This is bullshit anyway.

Honestly, fuck this bench off and be done with it.

have a card here with a uP6203 chip on it. here's the datasheet http://www.datasheetspdf.com/PDF/uP6203/844217/1 which pin do I need to solder and to where? here is a high res shot of the chip area http://imgur.com/ACSWhYy (zotac 9600GT 512mb) **************** nevermind, it was pin 11, i just didnt read the datasheet properly.