Reference RX480 support

[Niuulh]

Ok, fixed bios here:atiflash rx480 ln2. Run the approperiate .bat file as administrator to flash your card.

 

ASUSRX480.air

• Increased power limit to 150W (225W with +50%)
  
• GPU Voltage adjustment up to 1.4V in GPUTweakII
  

ASUSRX480.ln2

• Increased power limit to 150W (225W with +50%)
  
• Current and power reporting is half so power limit is actually up to 450W
  
• GPU Voltage adjustment up to 2.0V in GPUTweakII
  
• Fixed clock frequency at all times
  
• Fixed at PCIE 3.0 at all times
  
• Thermal reporting disabled (cold slow fix), be very careful and make sure you have good cooling for the GPU since there's no over temperature protection any more.
  

 

On the card I tested I had coldbug at -155*C, but it works fine above that even cold boot. It's a bit similar to GTX1080 when it comes to voltage and doesn't seem to like much more than 1.3-1.4V. I could run higher but it didn't gain me any frequency. For example I don't get display output if I try to POST with above 1.3V. The biggest obstacle is however the Crimson driver which saves your clock frequency each time you set it (even from GPUTweakII) which means you'll be booting with high frequencies. I could go into the OS with 1.3V set using eVc at 1700MHz core which helped a lot when benching this card. Similarly as with POST I would lose the display output if I tried to enter the os with above 1.3V.

 

 

 

It's just a test on ln2 to check issues etc. I'll leave the proper scores to you guys.

 

 

 

Thanks man.

 

Hi, thoses bios can work on my Nitro+ Saphire or it's only for Ref boards ?

[rockeur.alexis]

Hello all !!

 

Does anybody have a LN2 bios for the Strix edition ? Because the Ref LN2 Bios is not working on my card, impossible to have the display.

 

Thanks guys

[elmor]

I believe all you need is to run this tool from The Stilt StrixRX480_LN2, sticks after reboot.

[rockeur.alexis]

Hello, Thank you Elmor, it work i can go full pot but i have violant OVP, do you know how to go over it ? Because i can't put more than 1.325V ^^ The max freq GPU with this voltages was 1760Mhz.

[rockeur.alexis]

Well, its ok, i found a Vrmtool to push the VID ^^ Max for now 1800 but i'm sure that the GPU need more juice, the VRM are at their maximum.

Edited May 6, 2017 by orion24

[unityofsaints]

On 5/6/2017 at 9:24 PM, rockeur.alexis said:

Hello, Thank you Elmor, it work i can go full pot but i have violant OVP, do you know how to go over it ? Because i can't put more than 1.325V ^^ The max freq GPU with this voltages was 1760Mhz.

How did you manage to get the LN2 BIOS / LN2 tool working? I get bluescreen on reboot with both. In Windows 7 and 10.