Massman Posted October 25, 2012 Share Posted October 25, 2012 Hey all, So I had the opportunity to get some data from a bunch of A10-5800K CPUs. The CPUs were testing both on air with the TCI K² application and on LN2 (two bins). - Bin #1 = 1.85V, load bios profile and up multiplier - Bin #2 = max voltage, max clock Test Setup - A10-5800K - GIGABYTE FXA85X-UP4 (bios F2, F3i) - HD 7760D - Der8auer Fusion rev3 - Kingpin Dragon F1 Gemini 2.0 (Fast base) How to bin - install CPU - open the TCI K² application - go to CPU info - note down leakage info and VID Basically, you need a CPU that is - Ultra High Leakage - VID lower than 1.30V My results I tested two batches: - 1219PNN: retail silicon, same I used for the HWBOT Testlab #1 - 1239PGT: 'special' bin So far, the 1.2875V bin looks the most promising ... should try that one on LN2 I think . Just my 2c. 1 Quote Link to comment Share on other sites More sharing options...
rsnubje Posted November 2, 2012 Share Posted November 2, 2012 That's nice When are you gonna test the 1.2875 VID cpu? Quote Link to comment Share on other sites More sharing options...
Massman Posted November 2, 2012 Author Share Posted November 2, 2012 Hicookie already did [hwbot=2323708]submission[/hwbot] Fyi - now trying to figure out how to find good IGP chips. It's not just about low VID there ... Quote Link to comment Share on other sites More sharing options...
Xtreme Addict Posted November 2, 2012 Share Posted November 2, 2012 Nice! I will check my "6.9" chips how good they are according to K2 application Quote Link to comment Share on other sites More sharing options...
Tsunamijuan Posted November 24, 2012 Share Posted November 24, 2012 From my playing around with the trinitys so far it looks like you need a mix of mid to low NB voltages, along with good IMC strength. Though i really haven't put enough chips through my setups yet to build a reliable dataset to prove this. But its a starting point atleast. Since the best IGP numbers generally come from as high of NB frequency as possible. 1 Quote Link to comment Share on other sites More sharing options...
geforcelove Posted December 17, 2012 Share Posted December 17, 2012 (edited) thanks ~ ^^ may i have a 1 question? how about max voltage (trinity) for stable oc (usually using) ------------------------------------------------------------- now i use A10 5800K 4.6G (1.45/load LLC 1.472) /Tem max 60C(liquid) prime small mode 8H pass Edited December 17, 2012 by geforcelove Quote Link to comment Share on other sites More sharing options...
flanker Posted December 17, 2012 Share Posted December 17, 2012 depends at cooling...high air or allinone watter, you can set 1.55V. But there is a problem, you can have CPU part stable OK, but iGPU part not (if overclocked both parts in APU). With higher GPU clocks is harder to get more MHz at DRAM. Big stress for IMC. Quote Link to comment Share on other sites More sharing options...
geforcelove Posted December 17, 2012 Share Posted December 17, 2012 thanks u so much ur advice Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.