zzolio

nice i have to zombie my card stock vrm 4 phases

slow mode should be in the same option as QPI frequency

I use k70 plastic spray

I think it really depends on which pot you use

you QPI Frequency is to high use slow mode for 2D benchmarks

try ab 1,5

It is ref

They are all trying to kill you here

I think I will buy this week would be nice to test them when gigabyte has open OClab next weekend

nice cas 5 again

the address in the email is wrong it is 90 not 126

Arrived

Nice i need to bench 920 again

thanks 1.3 Vcore temp between -50 and -60 degrees

I have posted my best scores I hope it's enough

I had only had OCP before I made the mod no problems after

mods http://forum.hwbot.org/showthread.php?p=245437#post245437

N560Ti-448-12D5 unlock voltage in bios to 1.21 V http://www.youtube.com/watch?v=8iiJVcHkWPk I had OCP at 1.2 V 1100 MHz Vmods measuring points Vcore Vmem Vpll OCP VID mod if you use VID6 then the Vcore is 1.4 V set the voltage down to 0.913 V with software then the Vcore is 1.3 V load Now you can change the voltage from 1.3 V to +1.5 V all mods works on my card all mods are made at your own risk

Yep more than 1.21 V is hard mod

nice score

this will get you up to 1.21 V 1.2 V load http://www.youtube.com/watch?v=8iiJVcHkWPk

it can provide lots voltage 1.5V but mosfet gets too hot I will post mods if you need them

ref http://dk.msi.com/product/vga/N560Ti-448-12D5.html crap wrm

not much time left I can not wait to meet all you I will also go to 10AM - 1PM: MSI Keynote with Elmor talking about overclocking 11/06: ASUS

-50 1.2V I will try again when F1 is finest