zeropluszero

So use some teamwork and combine teams. ¯\_(ツ)_/¯

Haha what am I reading.

Looks like a nice IMC too dude.

#5 baby.

Pepi please link them to my thread where I have uploaded it. http://forum.hwbot.org/showthread.php?t=138687'>http://forum.hwbot.org/showthread.php?t=138687 The linked thread has ABX that I found on forums, and the one from Hwbot Should be in thread above.

Looks like its not truely dual channel, displays only one temp at a time, and the differential between the two. Sorry Doug, my search continues.

Killer!

Do you mean a tmd-50 model?

Haha, As I said above, I'm a collector, I don't know what like, 70% of these apps do.

greasy

Awesome Sof!

In Australia i use http://www.jaycar.com.au/Service-Aids/Chemical-Aids/Aerosols/Electronic-Circuit-Board-Cleaner-Spray-Can/p/NA1008. Maybe its not as good as CRC, but it is available a 5min drive away, cleans vas off sticks and sockets. http://www.ebay.com.au/itm/271393421887 http://www.ebay.com.au/itm/331877635501 http://www.ebay.com.au/itm/331648782271

Isopropyl alcohol spray. Magic spray. Because its MAGIC.

These chips sucked to bench man. Good one.

could probably hard mod the board if you knew where the voltage controller is.

Killed it.

This was all really cool stuff!

Need to do single card 03!

Nevermind then. I think maybe a voltcraft K102 is probably a better fit for me.

Pretty sure that might actually be more expensive than a fluke. How about, not more than 100euro

the team au legacy take back. I have waited so long....

Nice

6.7 who need?

Must display decimal after -100 (ie. -101.0) Dual channel Cheaper than a Fluke lol.

had the same thing happen this week at computex, probably just wet somewhere, safer to pull down, dry out before starting again.