dinos22

Hey Ronaldo, I'm not sure if you've done some of the steps to get higher uncore but here goes (for you and anyone reading) First up, switch from 2011 to 2083 pins (there is a switch near 24pin connector to the left) Second, you will know the switch is on when you find VL voltage in bios. You have to set VL4,5 and 6 to reach higher uncore and also RAM clocks. Start with VL4 1.45 VL5 1.45 VL6 1.45 VL4 and 5 help memory clocks and you can bump them up to about 1.55v depending on the CPU VL6 is dependent on the CPU and temperature. I suggest you to test what VL6 your CPU can take first so cool down the chip to -50C and start setting 1.45 first and then 1.48, 1.5 and then go in smaller increments (1.51, 1.52 ETC). At some point your chip won't like VL6 and will throw an error like B0 so clear cmos load profile and step it up again up until max bootable value. Then you can set higher uncore multi and either boot straight with high uncore or apply it in OS (if you are booting with low uncore multi, make sure you step up in a few steps to final value rather than try set highest stable uncore right away as it will not like it for a lot of CPUs) For high uncore you also need to set VRING voltage as well. Test up to 1.5v (actually try higher as well as some chips can respond to more)

Nice work Ney and Futuremark!

Well done mate

Grizzly paste on this run. It's alright

Nice work

Looking good

Opaaaa

expecting some huge 3D runs soon!

Bad wazza sof

nice work, big clocks

Thanks fellas, well played

crackin up Neil

Malakas having some fun

Bringin' it back home

Thanks! Flanker, just clocked down for final screenshot cause it's on the edge. It was run at 6149MHz

Hahaha is that Grizzly Adams lol

KA-mofo-BOOOOOOOOM

opaa

that is big

hahah soooo close

Everyone do giga first and we'll swing by corsair afterwards

opa

Got the champion cranking I see. Nice man

big!

Did you just grab my ass?