zippytek

awesome work!

there it is! congrats

"slow OS" effi looks *chef's kiss* nice!

awesome work, I knew you could do it!

anyone have anything working for command rate 1T on z790 yet? seems it will post in at 8200 C34 1T but I need to go down to 7400 to even attempt to boot windows...and then instant bsod (mem mgmt). will test more but curious if anyone has had success z690 dark was very strong for 1T...

Looks good, will give this a shot today. Was seeing much different behavior tuning mem v z690 dark and the voltage guidelines here explain it. Thanks!

poppin' bottles! congratulations y'all wow

00 like that usually indicates dead hardware. could be board or cpu maybe, have you tried doing a cmos clear? reseating the cpu?

Hey, here are a couple of things to try: -if you changed uclk mode to sync/async, set it back to auto (or sync if you have fclk and mem clock in divisible values) - e.g. fclk = 1600, mclk = 6400 -reduce fclk (or set it to auto if you changed it) -if you set manual DDR5 frequency/timings, or xmp, do the settings work for the above rules? if xmp is 6400, set fclk to 1600 etc. if xmp is 7200, reduce mem frequency to 6400 manually after setting xmp. **most am5 chips struggle to do more than 6400 but this may have improved with newer bios revs-if you're trying to boot above 6400, this might be all you need** In my experience, only 2 of my chips will run high fclk in async, but my 7900X maxes around 1800 and is happiest around 1600. 7950X does 2100+, 7600X same if all of this still gives 00, make sure your mem voltages are sufficient for freq/timings, then make sure things aren't too tight. hope this helps. GL

Great run!

wow, strong m die indeed. nice work!

Incredible stuff man, congrats!

Chip is insane. Awesome work! Congrats

Nice work!

sounds good, thanks. fwiw, it sounds like there is an issue disabling ECC on some cards too which makes this all even more fun.

Question then before I run some more 3D: Front page says: Am I reading this correctly? Any subs after 11/23 with older systeminfo *or* ECC showing "disabled" in 3DMark verification links will be invalid for hwbot? Please confirm or correct me. Thanks!

that is quite a chip! very nice

Nice work!

looks like a solid chip, great work!

strong work, 10K is close. let's go!

higher average clocks than the HOF, just incredible work man! chagall very op. congrats!

there we go. next stop: DDR5-10000

Looks incredible, finally taking down the 4x 1080 Ti WR. Congrats!

Let's go! Great work, keep pushing it. I know there's more in there...

what a beauty, very well done!