Very efficient run sir, well done

Yep, nice score. I'm completely new to this platform and it seems I run into dual channel issue yesterday but still I need to shave 1 minute off to be on par in efficiency.

Thank you sir. Still there is scope for improvement. If the priority is high/realtime hanging after 2 iterations. Above normal priority hanging after 20 iterations. This run was with normal priority.

ow I just ran full prio out of Benchmate, runs fine here, but too slow  on 8150 :p

nice chip and ram K , little more V may stabilise and give you more

With realtime/high priority 2nd iteration is completed around 1 min 11 sec & the run with normal 1min 13 sec. So if it goes through should be around 20sec faster. One of the problem is I use minimal v core. Definitely higher v core should do the run high prio & around 13min 55 sec. My former teammate & good friend knows, I use bare min voltage to run benchmarks. Ozzie opposite to me in that aspect.

Edited July 23, 20196 yr by ksateaaa23

6 hours ago, ksateaaa23 said:

With realtime/high priority 2nd iteration is completed around 1 min 11 sec & the run with normal 1min 13 sec. So if it goes through should be around 20sec faster. One of the problem is I use minimal v core. Definitely higher v core should do the run high prio & around 13min 55 sec. My former teammate & good friend knows, I use bare min voltage to run benchmarks. Ozzie opposite to me in that aspect.

yes K you have always achieved very good results on minimum vcore voltages, youre quite the mathematician, i have pulled back on the voltage aspect after the loss of too many boards i think definately attributed to the voltages aspect ?