Jump to content

Featured Replies

Posted

Hy boys,

 

i have some issues with this mboard. I'm benching on LN2 but i have debug code 03 and i'm not able to set up the bios. I have tried two 4770K but same problem.

What can be ? I'm using X08 bios, i have tried alsso F7 official, but anything new.

 

Thanks

  • Author
I had same issue with m5g - wet cpu was the reason. Also trls may be wrong.

 

really ? i have this problem also before benching, with cpu not wet.

  • Author
Are all pins in the socket fine?

 

Yes Roman, all pins in the socket are ok. I have cleaned the back ok cpu. Tomorrow I try again. I hope to solve.

Also when try again only use 1 dim in first or second slot

  • Author

I tried with backup bios...Same problem...On air mboard go normally...Only on LN2 03 error code lightning...Also with one dimm...

  • Author

I can try with new Gene VII soon...?...The temps when 03 code happens is around -20 / -30...If i boot around 0 and i set mem on bios can be normal...

My bet is on the mobo :) It's very good ofc, but I've had mobos that didn't like sub zero what so ever before.

What method of insulation are you using?

 

I had an Asus board doing a similar thing on subzero a few years ago and it was because there was too much vas on the board and some had got into the socket. Might be worth looking into.

  • Author

I use rubber on socket and armaflex, not vaseline. Mboard run well from July 2013 on subzero. Only from few days error 03 on just -15°...Tomorrow i check cpu on GENE VII...

Andreat85,

 

Do this mod to fix 03 problem.

 

short small resistor behind cap. enjoy :)

bXNIt16.jpg

 

what size resistor ??

  • Author

I have try also the MAXIMUS GENE VII mboard and same issue...03 code on cold...

 

There is a mod also for GENE VII ?

 

I sold GIGABYTE Z87X-OC perhaps...

  • Author
Andreat85,

 

Do this mod to fix 03 problem.

 

short small resistor behind cap. enjoy :)

bXNIt16.jpg

 

there is the same mod on Z97X-OC ?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...