Administrators websmile Posted April 9, 2017 Administrators Posted April 9, 2017 I posted a link to dowload at page 2, sometimes looking at the thread benefits Quote
hubip Posted April 9, 2017 Posted April 9, 2017 Ahh, yep. Sorry. U right, I not read through the whole thread.... Anyway, still nothing. I give up. I hope HWBOT accept the submission this way as well. Quote
TAGG Posted April 9, 2017 Posted April 9, 2017 You have to run this CPU-Z on Windows XP SP3 on SP2 the version from Websmile crashes too... If you have installed any CPU-Z (one of the Versions that crashes) you'll probably have to reinstall Windows (Deleting registry entries or uninstalling did nothing for me) Quote
TAGG Posted April 9, 2017 Posted April 9, 2017 Quick question: In which category should i submit if i used 1x XP3200+ and 1x XP 3000+ (on the same board as dual CPU setup) for stage 3? Quote
Mr.Scott Posted April 9, 2017 Posted April 9, 2017 The higher processor. In your case it would be x2 XP3200+ Quote
cbjaust Posted April 9, 2017 Posted April 9, 2017 (edited) Pin mods and bridge mods don't work on NF2 chipsets. Pinmod to the socket of a Gigabyte GA-7N400S-L which comes pretty neutered from factory worked for me on a TBredB 2600+ (AXDA2600DKV3C JIUHB 0345MPM), see here for example using x12 where the stock multi is x16: "][/url] Edited April 9, 2017 by cbjaust Quote
Mr.Scott Posted April 9, 2017 Posted April 9, 2017 You can always lower the multi on AXP's. They are all unlocked downwards. Most people that ask want to raise the multi. Rather than challenge semantics, you can always check what works at Fab51. Quote
cbjaust Posted April 10, 2017 Posted April 10, 2017 (edited) You can always lower the multi on AXP's. They are all unlocked downwards.Most people that ask want to raise the multi. Rather than challenge semantics, you can always check what works at Fab51. ah, yes, forgot about that, nevertheless pinmodding on nForce2 worked for me. Not much use for raising multi apart from 200MHz FSB CPUs as far as I can see... Edited April 10, 2017 by cbjaust Quote
hubip Posted April 10, 2017 Posted April 10, 2017 I made a win reainstall, then using the cpu-z from websmile. But always the same. Wierd.... Quote
TAGG Posted April 10, 2017 Posted April 10, 2017 (edited) If someone would help me with my efficiency on 01 i'd really appreciate that TAGG`s 3DMark2001 SE score: 6333 marks with a GeForce2 Ti Using following settings: LOD 2.9, RAM @ 1T timings, AGP @99MHz Still no idea why the result in dragothic is so bad EDIT: Idiot me forgot to install Chipset driver^^ Edited April 11, 2017 by TAGG Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.