zeropluszero Posted December 16, 2013 Share Posted December 16, 2013 http://hwbot.org/submission/2441729 because GPU clocks? Quote Link to comment Share on other sites More sharing options...
l0ud_sil3nc3 Posted December 16, 2013 Share Posted December 16, 2013 ^Don't think so because this sub was from a while ago, while this was from earlier tonight. . . 5Ghz look about right? Seems a bit low to me, and the scaling from 5Ghz to 6.2Ghz is not right. I have been trying a number of different different things and nothing seems to help. Quote Link to comment Share on other sites More sharing options...
der8auer Posted December 16, 2013 Share Posted December 16, 2013 Did you do the oc_windforce tweak with nvidia inspector? Quote Link to comment Share on other sites More sharing options...
l0ud_sil3nc3 Posted December 16, 2013 Share Posted December 16, 2013 ^Pretty sure everything is done tweak wise, LOD, D3D, Inspector settings, OC Tweak in bios. I have a pot mounted to the other 580 but refuse to start with such shit efficiency. I have tried input from as little as 2.04v to 2.7v with no difference. Maybe memory is too tight? I doubt it because the same settings have passed XTU lol I also just ran 03 in W7 x64 just now and scored 120k, help me figure this bunny out guys... Quote Link to comment Share on other sites More sharing options...
crustytheclown Posted December 16, 2013 Share Posted December 16, 2013 (edited) i would just turn everthing to stock in nvidia control panel and inspector and then just do d3d and inspector tweak nothing else... Your hole score is very low not just nature... Edited December 16, 2013 by crustytheclown because i can... Quote Link to comment Share on other sites More sharing options...
Splave Posted December 16, 2013 Share Posted December 16, 2013 580 need compatibility bits Quote Link to comment Share on other sites More sharing options...
crustytheclown Posted December 16, 2013 Share Posted December 16, 2013 or maybe you have chosen d3d compatibility bits and not PREd3d compatibility bits in inspector... common mistake... Quote Link to comment Share on other sites More sharing options...
Splave Posted December 16, 2013 Share Posted December 16, 2013 ^ exactly Quote Link to comment Share on other sites More sharing options...
Andrix85 Posted December 16, 2013 Share Posted December 16, 2013 If I able " PREd3d " my result dropp low, I don't know why... Quote Link to comment Share on other sites More sharing options...
Moose83 Posted December 16, 2013 Share Posted December 16, 2013 here it works fine on weekend Quote Link to comment Share on other sites More sharing options...
l0ud_sil3nc3 Posted December 17, 2013 Share Posted December 17, 2013 Pre D3D Compatibility bits is what I have set in inspector, so not that will try the back up board and see if it behaves the same. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.