l0ud_sil3nc3 - GeForce GTX 580 @ 925/1050MHz - 156701 marks 3DMark2001 SE

[zeropluszero]

http://hwbot.org/submission/2441729

because GPU clocks?

[l0ud_sil3nc3]

^Don't think so because this sub was from a while ago, while this was from earlier tonight. . .

 

 

5Ghz look about right? Seems a bit low to me, and the scaling from 5Ghz to 6.2Ghz is not right. I have been trying a number of different different things and nothing seems to help.

 

 

[der8auer]

Did you do the oc_windforce tweak with nvidia inspector?

[l0ud_sil3nc3]

^Pretty sure everything is done tweak wise, LOD, D3D, Inspector settings, OC Tweak in bios. I have a pot mounted to the other 580 but refuse to start with such shit efficiency. I have tried input from as little as 2.04v to 2.7v with no difference.

 

Maybe memory is too tight? I doubt it because the same settings have passed XTU lol

 

I also just ran 03 in W7 x64 just now and scored 120k, help me figure this bunny out guys...

[crustytheclown]

i would just turn everthing to stock in nvidia control panel and inspector and then just do d3d and inspector tweak nothing else...

 

Your hole score is very low not just nature...

Edited December 16, 2013 by crustytheclown
because i can...

[Splave]

580 need compatibility bits

[crustytheclown]

or maybe you have chosen d3d compatibility bits and not PREd3d compatibility bits in inspector... common mistake...

[Splave]

^ exactly

[Andrix85]

If I able " PREd3d " my result dropp low, I don't know why...

[Moose83]

here it works fine on weekend

[l0ud_sil3nc3]

Pre D3D Compatibility bits is what I have set in inspector, so not that will try the back up board and see if it behaves the same.