Official BIOS

ROG Rampage VI Extreme Encore 0401 Bios

Download : https://bit.ly/2OqWWOq

 

OCPACK

TurboV, MemTweakIt, OCPACK : https://bit.ly/2Ov7Br4

TurboV W7 : https://bit.ly/2LNcIBg (Windows7 use turbov old version.)

 

USB Flashback

 

 

LN2 OC TIP

Same as SKX, Enable ln2 mode, load ln2 profile, adjust volt and ratios accordingly.

NOTE: Default SATA mode is RAID mode so to boot into an AHCI Drive you need to switch to AHCI under PCH storage config

low core profile (10core or 12core or 14core)

high core profile (16core or 18core)

 

Big pots should be used for good temp control.

Typically, Coldbug temp is -100c ~ -110c

cpu voltage and cache voltage depend on cpu (etc 1.45 ~ 1.55) 

As with SKX, at -80c plus high mem freq like 4000, manually tune DQS and uncore voltage offset, whether its hard lock in os or AF/00 at mem training.

Set all to

And set uncore voltage to +0.25 and start adding uncore v offset from there.

If have good memory, 4000MHz 12 11 11 is very easy.

 

OCTOOL

Skewed voltage sets the specified voltage to the worst core and slightly lesser voltage to the better ones to minimize heat.

Skew ratio drops a certain percent of the worst cores to a lower ratio than the one specified while better ones remain at the specified ratio

Ratio hot key to hot key a ratio to apply, click start when ready

 

change the worst core voltage and percentage. (Depends on cpu)

 

change the cpu speed using hotkeys (ALT + A , ALT + B, ALT + C)

 

 

Enjoy!

 

 

 

Hey

Please fix the turbov win10 URL (its says that the file is infected with virus and cant be download)

Tnx

39 minutes ago, gkmltd said:

Hey

Please fix the turbov win10 URL (its says that the file is infected with virus and cant be download)

Tnx

It's not a virus. I think it's an error in Google Drive.

But I modified the download URL.

Thanks

Wish this board had a TB3 header, it'd be perfect then.

Both 4-way SLI/Crossfire and OC Panel support have been dropped ? That new utility looks interesting though, can it be used on other ASUS boards like the APEX?

Edited January 2, 20205 yr by unityofsaints

Hi Guys,

Before doing any overclocking on this motherboard (as well as on any other ASUS product) please disassemble it and check if everything is OK.

Was installing EK monoblock yesterday and found this shit.

800EUR mobo worked with thus stuff for 5 months

Edited May 29, 20205 yr by Nazar

Any tips for changing RTL/IOL? Even just locking in the boards auto values seems to result in a no post. They seem to train very funky when going over 4000 aswell so would be nice to sort them out. There is no round trip latency setting I can find that I know of like mainstream Intel Asus boards have.