September 29, 201212 yr GA-Z77X-UP7 - F5d GA-Z77MX-D3H TH - F4 G1.Sniper 3 - F8c GA-Z77-D3H - F19b GA-Z77M-D3H - F13 GA-Z77-DS3H - F10a
October 4, 201212 yr Asrock Z77 Extreme6 2.10 Flash Version Changelog 1. Update CPU code. 2. Modify CPU load line calibration behavior. 3. Add Gen2 and Gen3 speed option in PCIE Link Speed setup items. 4. Auto detects PCIE link speed.
October 7, 201212 yr Any hope for Gigabyte GA-Z77MX-D3H ?? I am experiencing ~10% lower performance in WinRar & PCMark7, with i3-3225 Ivy Bridge compared to the 200mhz slower i3-2100 Sandy Bridge..
October 9, 201212 yr Asrock Z77 Extreme 9 Flash bios 1.61 Asrock z77 Professional Flash bios 1.31C Â Changelog for every bios. Support Windows 8. Note: "Ultra Fast" is only supported by below conditions. 1. OS is Windows 8. 2. Graphics supports UEFI GOP.
October 12, 201212 yr Asrock Z77 OC Formula 1.42A Â http://picx.xfastest.com/nickshih/asrock/Z77OCF142A.rar
October 16, 201212 yr GA-Z77X-UP5 TH - F12a GA-Z77MX-D3H TH - F5 GA-Z77X-UD5H - F15t GA-Z77X-UD3H - F18e Edited October 16, 201212 yr by stasio
October 17, 201212 yr Y U No Have Mpower Bios ?  E7751IMS.H10 ==> E7751IMS.H24  01. Modify some string. 02. Fix Ipv6 function fail issue. 03. Fix some items of CPU Features form show error when load defalut. 04. Add'Win 8 Configuration' item. 05. Enable Secure Flash function. 06. Fixed using AFU3.03RC02 to Flash BIOS error. 07. Support check GOP driver in external VGA card 08. Fix some item can not change value. 09. Fix DRAM frequency incorrect issue when use Patriot PV316G213C1K memory and XMP is enabled. 10. Support MSI Fast Boot. 11. Fix system hang on 0x55 issue when use Team Team-Elite-1866 memory. 12. Fix system hang on 0x55 issue when use SPD 800MHz memory and Sandy Bridge CPU. 13. Add WHCK UEFI GOP TEST fail solution. 14. Fix item "Internel PLL Overvoltage" always Enable when over clock cpu ratio. 15. remove WHCK UEFI GOP TEST fail solution. 16. Set item "Intel C-State" to enabled when use some special cpus (such as i5-3475s which oc ability are limited) to over clock cpu ratio to the ratio higher than the ratio 4 cores can reach at the same time. 17. Fix item "Adjust CPU Ratio" show error when adjust cpu ratio. 18. Fix the issue that BCLK can not fix at 100.5 MHz after clear CMOS. 19. Fix windows boot manager boot sequence show error issue when load default after. 20. Fix can't adjust CPU voltage over 1.53V issue. 21. Remove Secure Flash function. 22. Remove solution:Fix TPM ID issue. 23. Remove pop box of 'cpu ratio'item. 24. Fix oc profile fail. 26. Add OC Retry Counter Item. 27. Add code for MSI Fast Boot. 28. Next boot after AC power loss run normal boot when fast boot enabled. 29. Support check GOP driver in external VGA card when fast boot enabled. 30. Modify 'Win 8 Configuration' to 'Windows 8 Configuration' 31. Add solution:Realtek LAN WHCK-Debug Capability Test fail when memory > 2G. 32. Improve system stability when use AVEXIR AVD3U26661104G-4CM memory and XMP is enabled.   E7751IMS.H30 ==> E7751IMS.H41  01. Fix can not adjust cpu ratio when item "Hyper-threading" set to Disabled and item "Active Processor Cores" set to 1. 02. Adjust CPU Ratio keyin function. 03. Add win8 gop solution.  E7751IMS.H41 ==> E7751IMS.H42  01. Update the CPU Micro Code M12306A9(015). 02. Fix UpdateBiosAndME function issue. 03. Fix Possible Black Screen issues with GOP Driver. 04. Fix Avexir 2400(patched before) S3 wakeup failed. 05. Update Realtek uefi driver. 06. Update CryptoPkg Module 010. 07. Fix Winxp 64bit S4 error issue. 08. Update Intel Ivy CPU GOP ivy_30131013T01. 09. Fix post code show error issue..    E7751IMS.H42 ==> E7751IMS.H43  01. Fix WIN7 64 bit os S4 resume show error message issue. 02. Update ME8.1 1318. 03. Fix System cannot Enter windows 7 most of the time and will just show the message no bootable device found.   E7751IMS.H43 ==> E7751IMS.H44  01. Update Post Time Tuning module 12. 02. Fix it cannot finish Windows 7/8 UEFI Installation When you set the bios boot sequence to SATA HDD as 1st Boot and DVD ROM as 2nd boot and save and exit, then Press F11 to select UEFI DVD to Install. 03. Fixed it will hang 0xAD when use Non-GOP card and enable WIN8.   E7751IMS.H44 ==> E7751IMS.H45  01. Add the solution When you plug DVDROM as SATA 1 and plug SATA HDD as SATA 2 then system cannot Enter windows 7 Legacy OS after system restart from E7751IMS.H43. 02. Remove solution Fix it cannot finish Windows 7/8 UEFI Installation When you set the bios boot sequence to SATA HDD as 1st Boot and DVD ROM as 2nd boot and save and exit, then Press F11 to select UEFI DVD to Install. 03. Add some Multi-Lauguage about fastboot. 04. Change "Boot option filter" to "UEFI and Legacy" when Win7 mode. 05. Fix it cannot enter UEFI Windows after restart OS when set admin Password. 06. Fine tune advanced timing(TWRDRDD) for memory frequency >= 2600Mhz.   E7751IMS.H45 ==> E7751IMS.H47   01.Fix issue:Wakeup from S4 failed under Windows7 UEFI mode if you set Administrator password and set the Password check to ¡°BOOT¡±. 01. Fixed "Output Select"item can not working correct. 02. Remove "Press <DEL> or <F2> to enter setup." from post.   E7751IMS.H47 ==> E7751IMS.H51  1. Fixed compatibility issue with Roccat Isku keyboards not usable before OS.  + more unknown for now.
October 19, 201212 yr Asrock Z77 OC Formula 1.42g  http://picx.xfastest.com/nickshih/asrock/Z77OCF142g.rar  GA-Z77M-D3H - F14a GA-Z77-DS3H - F10b Edited October 19, 201212 yr by stasio
October 19, 201212 yr MAXIMUS V FORMULA BIOS 1309 Improve system stability. Â http://support.asus.com/Download.aspx?SLanguage=en&p=1&s=39&m=MAXIMUS%20V%20FORMULA&os=10&ft=3&f_name=MAXIMUS-V-FORMULA-ASUS-1309.zip#MAXIMUS-V-FORMULA-ASUS-1309.zip
October 20, 201212 yr MAXIMUS V FORMULA BIOS 1309Improve system stability.  http://support.asus.com/Download.aspx?SLanguage=en&p=1&s=39&m=MAXIMUS%20V%20FORMULA&os=10&ft=3&f_name=MAXIMUS-V-FORMULA-ASUS-1309.zip#MAXIMUS-V-FORMULA-ASUS-1309.zip   i did that one and now i cant get my memory above 1866 (thats its standard, the max i can is 1800) before it was working fine. and my cpu oc'ing is totally f*** can i flash it back to the previous one ?
October 20, 201212 yr I haven't tested this bios , but i thought it was OK as it's an official .  You can easily flash back with USB ROG flash function  http://rog.asus.com/forum/showthread.php?1142-How-to-use-ASUS-ROG-USB-BIOS-Flashback
October 21, 201212 yr so its safe to flash it back to 1302 ? !! i am having 1309 right now !!! is the flashback function available on the V Gene ? and what do i need to do ? Â Greets
October 21, 201212 yr You can do it I think. Use ROG USB Flashback. Â http://event.asus.com/2012/mb/USB_BIOS_Flashback_GUIDE/
October 21, 201212 yr i'm havin a Z77 board , the link you gave me is for x79 Â and i found this : http://smarttechtips.blogspot.be/2012/08/how-to-donwngrade-asus-bios.html
October 21, 201212 yr Crew principle is the same, just rename the bios file, put USB stick in the white ROG USB port. Then press the ROG button till it flashes. If it stops after a while the flash is done... excellent tool...
October 21, 201212 yr oke great but how do need to name it ?  i think when i see tis : Rampage IV GENE ----> R4G.CAP that i need to do this : Maximus V Gene ----> M5G.cap  correct ?
October 21, 201212 yr That is right. Â Tested 1309 too,it is crap.After a few restarts memory won't make over 1600(that is spd),no matter what value set in bios it will not apply.Overclocking on processor is the same as 1101.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.