May 15, 201015 yr Im gonna do this mod on the h55m-USB3 I think its the same spot as the the last 2 pics. Ill post results. EDIT so far so good. the mod went fine and I can boot in at any temp I went as far as -145c and no problems. FOR THE RECORD THE LAST 2 PICS WORK CB MOD ON H55M-USB3!!! THanks again! now if anyone can help me remember my settings. Thats another story.
October 2, 201015 yr sorry to disturb here. maybe it's a bit too late but is there anyone happen to know the VCORE Mod for MSI Trinergy?
October 2, 201015 yr sorry to disturb here. maybe it's a bit too late but is there anyone happen to know the VCORE Mod for MSI Trinergy? is the pwm controler chip a up6218 ?
October 2, 201015 yr Yes it is, the same as gd85. Should i follow your guide in benchtec? Edited October 2, 201015 yr by Sanko
October 2, 201015 yr Yes it is, the same as gd85. Should i follow your guide in benchtec? hey the youtube vid is for cold bug mod (lol you edited^) if its the same controller as the gd 85 then heres a link to the gd-85 volt mod http://www.benchtec.co.uk/forums/showthread.php?t=5854 also consider if the max is 1.7v in the bois you have the voltage dipper for 0.2v i know with the gd -80 if you set 1.7v in the bios then click the dipped you get like 1.88v just test it out say set the voltage in the bois at 1.1v then probe the V-read point click the cpu dipper and probe again im sure its a 0.2v jump cant really check as the triergy i had the dr mos blew up when they got wet
October 2, 201015 yr hey the youtube vid is for cold bug mod (lol you edited^) if its the same controller as the gd 85 then heres a link to the gd-85 volt mod http://www.benchtec.co.uk/forums/showthread.php?t=5854 also consider if the max is 1.7v in the bois you have the voltage dipper for 0.2v i know with the gd -80 if you set 1.7v in the bios then click the dipped you get like 1.88v just test it out say set the voltage in the bois at 1.1v then probe the V-read point click the cpu dipper and probe again im sure its a 0.2v jump cant really check as the triergy i had the dr mos blew up when they got wet yeah... iirc, in bios i set to 1.71v then after pushing the switch it's 1.8v. too bad now do not have the correct VR to apply the mod. only had 20K. thanks for your guide though.
November 5, 20196 yr Reviving an old thread lul, mod yet untested but this should be the resistor to short for CBB on a maximus 3 gene / maximus 3 formula, up next gotta figure out my P7P55D
January 10Jan 10 I can confirm that Tagg's mods also work for the GA-P55-USB3 board. It helped me during CC2025.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.