Chilli-Man

Thanks guys

In for dinner and drinks

Anyone hit issues with OCP on volt modded cards? I had to limit my vcore to 1.33v to be able to get through a run at 1600mhz without the card turning off.

But then I won't be able to find anything...

I'm in for sure

LOL, let me know if you figure out how to replicate it

Just noticed that the rules pages mentions needing a GT 730 for stage 1, but it's not mentioned on the stage 1 page. I also think I've read elsewhere that it didn't matter what GPU was used for stage 1. I'm just using a GT 710 currently, as my 730 hasn't arrived yet.

Link doesn't work for me.

Thanks Yes, I see that now, sorry must have missed it before.

Are there any restrictions on HW, like no ES CPUs or similar?

I've noticed the rules state each stage finishes at a different point through the month, but each stage itself says it runs for the whole month? Also, is the z170 ln2 board allowed?

26th to the 3rd for me. My first computex, and to say I'm keen would be an understatement.

I'll take one E6300 and one E6750 thanks

Working nicely now thanks

This one?

both this version and previous seem the same. logs attached. I have to leave monitoring off, otherwise the whole program will crash and close shortly after starting the scan.

No change in monitored voltage when trying to apply an offset, but the custom command is still working.

Monitoring is working now, but the voltage offsets wouldn't apply. So I did it manually with the custom command, and each step was another 100mv.

Thanks for your time and patience with this. I'll try it out and get back to you with the values after Christmas when I get back home.

Tried it and it worked. No lockups, and the core voltage got a small bump. It was fluctuating a little bit though, and GPUZ monitoring would drop out every so often. Losing comms?

What happens if it's wrong? And would you try it on your own card? Happy to take the gamble if you think there's good odds it'll work.

Tried applying a voltage and I didn't get any change in the output voltage when measuring it with a multimeter. PC just locked up and the GPU voltages stayed the same.

I'll take one of each if there's any left thanks

Ah, ok then. Tried that and step 2 worked fine. Step 3 gave the usual hard lock, so I took a photo.

Hey, sorry about the delay, but have set it up and had another crack. Still getting a hard system lock when trying to apply a voltage. I also tried sending the custom commands, but it failed at the 2nd one. I've attached the reg scan and a screenshot of the settings used for it, plus a screenshot showing the error when sending custom command #2. Thanks