TerraRaptor

Great pretesting

very strong.

You must check if stock pwm controller has any kind of PowerGood (VR Read outputs) etc. For older stuff (TUSL2) I had to keep stock FB line to stock VRM to make the board working properly. And yes, you should plug 12v connectors to VGA even with e-power as other power lines (MEM, VTT etc) may depend on it.

Try win phones - hwbot works quite good.

R9 290X crossfire

http://occlub.ru/forum/attachment.php?attachmentid=4470&d=1391805711

>What mod do you have for vcore?A trimmer around 500k between ground and fb? Nope, board is e-powered.

My ram is unable to go tRC=7 even @150mhz. And if i have LN2 to push 230*9.5, I would better try freezing ram and go 200-210*10.5 1:1 2.2.2.7 PIII 1.4S to break 1 minute.

Oh, I should make 1.266 a try. Thanks for the tip, i'm newbie with this socket)

Congrats!

Good run) my wife has put my only PIII 1.4s somewhere so I need to find it first) Hope to post my result tomorrow)

Insane overclock! Well done Max. Go for WR)

we all know havli is right)

Nice one!

Well done Michal!

settings hidden (coomand line unavailable) - invalid submission.

try "one two")

Such tweaks are forbidden here @hwbot. It is forbidden to run benchmarks "indirectly".

I have all except stage #1 which is mainly the matter of buying it. But will probably participate only stage #3 and #5.

Well done

I think Vnb may yield some stability for long benches @high FSB + tight timings. I plan to check this somewhere this week when I find my best Coppermine 733. I don't think that Vnb effect can be seen from CPUZ valids.

yes, GraduS did this with all @air

yes, possible. The only thing is every shutdown will make you set voltages again as the SATA power will be used without Asus mobo.

>Setting Decimals? LOL!

me too don't like inconsistency of new benches (catzilla is da worst for 4gpu CFX setup - 2 different runs have 1.5 difference with just the same settings).