Lucky_n00b

KABOOM! Congrats!

Awesome! Keep pushing it! :D

*speechless

Pretty decent score :D

Cool - I'm ok with 10 days before end, that's plenty. Thanks for confirming same one board + one cpu type, similar to Open DDR4 comps then

Hi, Question : 1) All participants must use commercially available components and software (Engineering Samples and Biosses are not allowed). Can you help elaborate, is this means OFFICIAL BIOS & XOC Tools on the website only? or both tools and BIOSes just need to be available here on HWBOT before competition start? 2) All participants have to use the same platform (CPU & motherboard) for all stages. This means the exact same motherboard and same CPUs? or just same chipset and CPUs? (e.g If I use Z690 UNIFY-X and 12900K, will I be allowed to use Z690 APEX + 12900K later?) Thanks

That memory Config is amazing - keep pushing it :D

It is a non-K CPU, so no matter what you set, it is currently maxxed out at 41x all-core turbo. Max BCLK i can do from BIOS is around 102Mhz, setting at 103Mhz failed, still checking with other boards to see if the bclk can be higher.

Congrats to all, glad to be able to participate this time - see you in another competition and keep pushing it

Congrats for the DDR4-7000 - Very strong!

Nice! I'm considering LM earlier but didn't do it because my block is pure copper and LM will stain it - maybe I'd find some nickel-plated blocks and try again with LM. Keep pushing it, cheers

Seriously awesome chip there - decent temps too, liquid metal?

Strong! Keep pushing it :D

Congratulations for entering the sub 4min 32M - awesome score man !

AWESOME!

Nice clocks on water :)

A little bit more to sub 4mins club - keep pushing it!

Unfortunately I have tested very small numbers of samples for Hynix DJR (only 3 kits total, this hyperx 4600, V-Color 5066, and a local RAM brand called V-Gen rated at 4600), so can't really be sure if the PCB component making much difference between these 3, all used what looks like 'A2' PCB to me. From my side it's the memory controller on CPU that might be more important, from 3 RKL CPU I have, this particular one managed to boot at DDR4-6200+ on ambient, while the other two won't budge past DDR4-5866 even with the same exact board, RAM, and voltage.

Need clarification : Showing all R23 window + the rendered screen without cpuz/benchmate obstruction mandatory? *If yes then probably need DSR/VSR to 1440p

Strongggggggg

Not bad? That is GODly for a 50 USD kit - I'd happily pay 150 USD for this kinda stick hahahahah

Thanks! Me too, I was not expecting this micron to be this strong for clocks, (but then again I don't usually bench micron kits in the last 2 years), this is best sticks out of 4, I got big variation between them, maybe because this comes from lower bin model (3600MT/s), but the worst stick still managed to boot 5500+.

Strong score to finish stage 1 - congrats

Hahahah still pushing for Stage 2, no worries Dad ?

Have to call GG on this competition, those DJR were very strong indeed! I tried to push the rev3.32 microns as hard I possibly could, frequency is priority for AIDA64 read but my DDR4-5466 18-24 wasn't enough to catch up the b-die level let alone DJR, got good learning experience out of it anyway. Waiting for the Lucky Draw then ? - keep pushing it bros