FireKillerGR Posted July 4, 2018 Posted July 4, 2018 (edited) For sale a 7980xe. Runs 5.5G on every kind of 3d benchmark on ln2 easy. It is bought from Caseking and comes delidded and with the die lapped. In case you need water results I will have to test it tomorrow and report back. Price 1500€ Edited July 4, 2018 by FireKillerGR Quote
SparkysAdventure Posted July 4, 2018 Posted July 4, 2018 The die is lapped? Isn't that dangerous? Quote
FireKillerGR Posted July 4, 2018 Author Posted July 4, 2018 10 minutes ago, AutisticChris said: The die is lapped? Isn't that dangerous? nah, works perfectly fine Quote
unityofsaints Posted July 4, 2018 Posted July 4, 2018 2 hours ago, AutisticChris said: The die is lapped? Isn't that dangerous? I think he means the IHS. Quote
FireKillerGR Posted July 5, 2018 Author Posted July 5, 2018 33 minutes ago, unityofsaints said: I think he means the IHS. IHS isn't lapped. die is 1 Quote
unityofsaints Posted July 5, 2018 Posted July 5, 2018 4 minutes ago, FireKillerGR said: IHS isn't lapped. die is Hmm ok. Writing looks very faded in that one pic but maybe it's just the angle. 2 Quote
Splave Posted July 5, 2018 Posted July 5, 2018 22 hours ago, AutisticChris said: The die is lapped? Isn't that dangerous? helps since middle of die is raised quite a bit Quote
FireKillerGR Posted July 5, 2018 Author Posted July 5, 2018 new photo of the cpu so you can check the ihs. Quote
SparkysAdventure Posted July 5, 2018 Posted July 5, 2018 Generally how far can you lap a cpu before it dies? Quote
Fasttrack Posted July 5, 2018 Posted July 5, 2018 Just now, AutisticChris said: Generally how far can you lap a cpu before it dies? Usually, when you find out it is already too late, lol Free bump for a great guy 1 Quote
SparkysAdventure Posted July 5, 2018 Posted July 5, 2018 Does the same problem happen in smaller cpus? I might want to test this on a g3900 Quote
FireKillerGR Posted July 5, 2018 Author Posted July 5, 2018 if u are not doing direct die I doubt its needed. On the above cpu it was needed as contact with both pot and wb was really bad 1 Quote
FireKillerGR Posted July 6, 2018 Author Posted July 6, 2018 (edited) Feel free to send offers via pm Edited July 6, 2018 by FireKillerGR Quote
OCX.Chile Posted July 12, 2018 Posted July 12, 2018 (edited) On 7/7/2018 at 7:03 PM, FireKillerGR said: lets go 1400€ for the cpu Did you submit some 2D Benchmarks like R15, x265, etc? How much freq. you achieved? Edited July 12, 2018 by OCX.Chile Quote
FireKillerGR Posted July 12, 2018 Author Posted July 12, 2018 I honestly didn't. Only used for 3D (vantage, 11, ts etc) where it does 5.5 quite easy Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.