Mr.Scott

Oh, you didn't know?....It depends on who you are.

I understand that, but consistancy in enforcement can be upheld. Also, I find the sarcasm you use when backed into a corner, amusing.

Not at all. Is this not the stance you've taken with everybody else from day one? Refering to the "actions without proof" of course.

Irrelevant. Prove beyond a shadow of a doubt that they're done by the same person or are using shared hardware.

This. ^^^ You've always stated that HWBot will take no action without undeniable proof......well, show the proof that they're sharing, or have intent to share.

That would be Crucial PC133. Micron chips.

I HAVE seen it for myself. I report a few every day. Unfortunately, trying to get them fixed takes an act of congress, because everybody has an excuse. Rewarding faulty submissions is not the cure, it's welfare, and will stop nothing.

Ridiculous. You want to reward entries with errors now? Bring it on. I can make a lot of mistakes.

You're comparing apples to oranges there. A little common sense goes a long way here. Splitting hairs to find loopholes in the rules is a tough road to travel my friend. I'm just sayin'.......

Lol. No doubt.

I think "ERROR IN COMPUTATION" makes it quite clear. Old or new rules make no difference in this case. ERROR means invalid.

You're much more patient than I am. I have a hard time waiting for PIII's to finish.

Both links are identical to me.

It's on one and two (#19 and #31). I think it's because there's no zero in the .xxx part of the time and the DB can't decide where it goes. You need to start putting all three numbers in buddy.

Be careful. This opens up a slippery slope. If you change that 550 category, does that mean you'll be changing the other categories that have Black Editions lumped in with all the other submissions? Eg: 5400+BE Or are you willing to separate all the categories by stepping/revision?

Congratulations Team OCX. Nice runs. We will meet again, I'm sure. ~Team CP

Nice run on water buddy. Your team appreciates your effort.

That's too bad. That was a great OC on that chip.

Good run but, no official backround in SS????

I fully expect there will be.

Those pins are your problem for sure, and the extra jumpers WILL give you more voltage just as Turrican says.

I use the same adapter. The only jumpers I use are on A5-6 and B8-9, and it works just fine. All other adjustments I make in the bios or SetFSB. Hope that helps you a little.

Which adapter?, Powerleap or Lin-Lin?

Still limited to 3.4v though.