March 14, 201214 yr Author Thanks guys 2,17 Kg incomming! @ Kenny: No it's a complete new pot. Still looking for the right name.
March 14, 201214 yr Author "Der8auer Inflection+" Haha epic nice pics too Thanks my friend will you bring some to the EOS? would be nice. Ofc Didn't forget that you asked for a new pot
March 14, 201214 yr Author Yea der8auer-NDA No The bottom part is just not 100% finished and needs some polishing Also the mounting Kit is still missing.
April 6, 201214 yr 1. the exposed ring freezes up fast and lots of condensation forms. 2. the extra large hole isn't friendly with the regular thermocouples. maybe add a small hole
April 6, 201214 yr Author 1. the exposed ring freezes up fast and lots of condensation forms. 2. the extra large hole isn't friendly with the regular thermocouples. maybe add a small hole 1. It's only few mm and due to the POM mounting plate there is no big "cold transfer". 2. The hole seems a lot larger than it is because of the angle. It's only 2,5mm diameter. My old Pots like BEAST rev1 had 4,5mm hole and I read all the opinions of the last publishing. So the new pot will have only 2,5mm looks good any info about price? Thanks Will publish the price in few days on my homepage. Edited April 6, 201214 yr by der8auer
April 7, 201214 yr Author Well the condensation around the top is not a problem. Took this picture after 4h of benching: You can see that the mounting material is very good and there is not much ice on the top Only ~1 cm around the top. Edited April 7, 201214 yr by der8auer
April 7, 201214 yr why don't you make it flush with the bracket? it'd lessen the frost on the exposed ring
April 7, 201214 yr Author It was planed to be flush at the beginning. These mounting plates are water jet cutted. I ordered 14 mm black POM. Last week the guy calls me and says they only have 10 mm white left... But it still works fine
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.