Jump to content
HWBOT Community Forums

Splave

Members
  • Posts

    5926
  • Joined

  • Last visited

  • Days Won

    140

Everything posted by Splave

  1. good guy l0ud shows RTL/IOL Clean run bro
  2. ES also forgot max mem was set lost a little bit of points oops
  3. Gskill 3200c16 4x4GB DDR4 Samsung IC's Each boots 4200mhz+ Air on z170 all air cooled 1 Stick had a wonky spreader and I changed the back side pad on it, not visible and looks totally normal now. (see pics) $180 shipped Kingston 2666c13 4x4GB DDR4 Hynix MFR IC's Untested, selling random kits (5) Saved for rainy day no longer needed. $125 shipped Panram 3200c16 4x4GB DDR4 Hynix MFR IC's Pulled from daily $150 shipped International buyers add $30 shipping flat rate non negotiable
  4. Got that all yesterday. It happens when it's very unstable here. Or when you try to load profile on new xtu that you benched on old version.
  5. Reference For Die Size and to show no FIVR in the way. Test Used: Wprime1024 5.1ghz 1.48v Before: 96C hit and failed within seconds (hard to tell what load after 2 minutes would have been probably 105+) After: 78C Warmest core and passed :thumb: Under ln2 without Delid running XTU we are going postive temps at -145c hits 20c loaded. :o So I would suggest everyone delid Replace TIM under IHS and then put IHS back on. Skylake bottom Devils Canyon top The PCB is thin and Ive heard of it breaking in a vice, so I would stick to razor. Press in on each of the 4 corners then do the sides last. Vice method fail (not me lol) Also would suggest if you plan to let the ihs float instead of resealing (so you can keep it fresh) loosen the hold down first so you arent forcing the ihs to slide forward under pressure, then tighten the screws after brining the lever down
  6. are you sure? I have 1640 at 5.2ghz seems right in line to me
  7. I like heat gun heat up the whole board PCB then Air Compressor blow as much off as you can. Then CRC Quick Dry Contact Cleaner for the residue.
×
×
  • Create New...