Splave

he is Lam John

in a leeg of his own

send me your titan I will see if I can replicate

time for amd blarg

bwahahaha didnt think I was that ugly, good to know

whens the mem pot ready!!!!

I didnt win a prize. Thx ASRock!

lmao amazing one

nailed it!

4k cherry

did you heat the vaseline up to flow it?

$339 on newegg, if you live near a microcenter (ofcourse I do not) $279+tax=$300

First time on the baby board, just a monster for hynix. You read people saying this and you think yeahhhh surrrre but this was quite easy to accomplish on it. The mem is scaling like crazy I believe Im being held back by my retail IMC, will try ES I think that has a bit more ballz tomorrow and update. This CPU and stick will run 1770mhz 1.65v on air for reference 1930 1.725vDimm :eek::eek: 1990 1.775vdimm 2057 1.85vdimm More to come :yepp:

nice charles, good talking to ya

KPC Ney Pro Mem Cooler How to go sub -100c A couple people have asked me why the ney pro is only good up to around -80c to -90c. So here is a guide to hit crazy cold numbers using the ney pro. First off get rid of your stock heatspreaders. It doesnt matter how "good" or "heavy" they are, (I will say the dom GT are okay) they are not optimal for benching cold. Heat them with a hot air gun or hair dryer for a minute and they will come off easy everytime. Measure from middle of slot A1 to middle of slot A2 (asrock z87 formula is 19mm)It will probably vary slightly by manufacturer. Mark this in permananent marker on the pot trying to center it best you can. You dont have to get too anal here. Next get some good quality tape and slap it on the insides of the spreaders. I suggest something sticky and thin as possible as it will hold the dimm while mounting even before you screw it in, and thin because large pads tend to crack under extreme cold. trim the excess with a razor. trimmed up and peeled read to receive the dimms. so you are going to go ahead and stick the dimm to the skinny side first backside view this is a very important step, you want to tim the top of this skinny peice before you join it to the fat piece. Joing the skinny and the fat. things get a bit messy but just have some paper towel on stand by cleaned up Now more tim. This time on top of that fat rail. This will be between the pot and spreaders so be generous. place the mounted dim on the pot and aim for your little dashes. If not perfect just shove it over a bit. And finally tighten down the screws when you are lined up with your dashes. Repeate on the other side. Last part is placing your probe. Best spot to do this is shown. I like to thread it through the pot side hole twice so if I snag the chord it wont pull prob loose in the middle of a session. I like to put it on the inside side and try to push it 1/4 or more inside the spreaders (under the tape). Pot should now be good up to -150 to -160 depending on ambient and other weather factors.

trade you my puppy?

^ agreeeed this is 6.6ghz 4c8t valid.....boot 6.4 4c8t 1.8v 2.4vccin but wont run 1m hmm try 2 cores tomorrow

^understood, but not bad for just buying 2 retails :D

very cute baby, and very faster computer lucky man

winning ? Direct booting

L311B516 trying now last one

http://hwbot.org/competition/asrock_richland_contest/

closer :!

lol!

;}