FireKillerGR

hvala puno bro!!! :D

Up

Bump

For sale the card I used for the qualifers of GOC 2018. Ran Timespy GT1 at 2685/2120 and GT2 at 2655/2120MHz. Also runs GPUPi at 2715Mhz. https://hwbot.org/submission/3985005_ Comes with brand new/unused Bitspower waterblock and backplate. Card is insulated. Price is 1800€ Photos to be added tomorrow

Holy sh*t... the amount of spam is next level. lol

lol why? Will do 7.6G that way? Congrats Frank. Nice time & cpu

3dmark time spy extreme (its physics test scales with cores and uses avx)

bump

interest for the R3B; please reserve

For sale our good 8700K and one of the best found. Runs 6940 MHz R15, 6860 MHz Hwbot 4k, 7.2 GHz 03 and 05 + 7330-7340 32M. Price: 700€ shipped. Voltages will be supplied as well. Note that the corners are a bit "chipped" (you can see on the photos) but has been like that for almost a year and runs without any issues. Liquid metal due to having it on my main rig for maximum gaming experience Original IHS will be included as well. Some results of the cpu: https://hwbot.org/submission/3895029_ https://hwbot.org/submission/3895725_ https://hwbot.org/submission/3897191_

Hmm what about 1200eu for someone who just wants the card only without cooler? Wont get any lower than this Open to trades as well

1st I believe

bump

Yes thats the connector. New cable is required and oc panel will work with z390 mobos as well (gene at least has support for it)

It actually has but it isnt the full length port as it was in the past. Its located in the bottom right side

its to be tested. Goal was the 5k+ elite points before the new revision is released; thats what we focused on.

yeap; was expected that catzilla 720P would turn into a cpu benchmark at some point

Bump once again :3

Bump

Its actually 3 but still

Yeap we keep both between that and had no issues.

As most of you know, ASUS released a new beast based on x299 chipset that looks like an improved hybrid of VI Apex & VI Extreme. Before we continue, have a look on Elmor's guide for R6A since most of the stuff remain unchanged. Main changes First of all its a 4-dimm motherboard that has no issues running 4k+ 12-11 tight on air without any kind of voodoo/magic. Using the b-die profile makes everything super easy and we were able to run both A1 and A2 mem kits without any issues. Also, as you can see below the power delivery got upgraded as we now have double the amount of VRMs we had on Apex Original heatsink now also has 2 fans to assist with cooling whenever load is high. Running on LN2: As mentioned above, you can refer to Elmor's guide to get things started and have an idea of what voltage does what and what the ranges/suggestions are. Overclocking a power hungry chip like the i9 9980XE was like a walk in the park and no issues (so far ). A nice baseline follows: - Just disable the ordinary power saving/cpu features and the devices you might not need. To disable RGB etc use stealth mode that can be found on the devices tab. - Set LLC to level 6, VRM current capability to 240% and whatever else you like to adjust for xoc. - vCore 1.47~V is what worked for both the 7980XE and 9980XE we tested but keep in mind that some benchmarks and chips will need less/higher vCore to max out. - Input voltage: 2.1~v is what we used for most of the chips we ran and had no issues running from 5.5 (retail 7980xe) to 5.9+ GHz. - Cache voltage: 1.3~V is ok to run cache at 3.8-3.9 on our cpu. You can try higher if you see scaling. - SA/IO: 1.20-1.25~V on both works fine for 4k+ quad channel. Note: LN2 switch isn't necessary. We could run using the above voltages and have LN2 switch disabled without issues. The above voltages are more of a baseline and tweaking is needed to max out your cpu, cache or mem freq! In case you remove the OLED display that comes mounted on the heatsink, you can use OC Panel or Roman's debug tool to check the post codes. Here is the R6 OC Pack that contains most -if not all- of the stuff you might need. Will post more if we find anything that might help.

For sale the card as the title mentions. Clean and comes with arctic accelero xtreme iv. Price 1400€ shipped

special SPD that does magic :3

@CSN7 this one runs A2 mems without issues (not sure Apex does) @4000+ tight. Also it has more phases so power limitations have been lifted. Which means that you wont have any issues that you *could* have on an Apex (we didnt have any on our tests last year but we were running only 3D) @Ikki thanks bro ^^ @H2O no need to use that. Raptor was already tweaked for last year's SLI setup so it was a bit of extra trimming on top.