Noxinite

Crazy!

Not looking to buy, but curious if you tested valid @1.45V?

OCN taking on 3870x2!

Nice!

Do you not get the "volt-boot" issue on the Giga P45s?

My two good sticks either won't boot or will not complete 32M and my back up sticks need RCD7 for 1850MHz. The D9s I have are just as bad and need 2.05V for 1800 7-6-6. From the loops I did manage at the same FSB with 984C6 hypers it should have been in the low 50s.

I'm aiming to make it, but no guarantees.

Especially on non-chilled water and no delid!

Nice. I'm going to run this on phase next week.

Awesome!

I have no NB pot, but it would be nice if it did.

Sam is OP!

Smashed it!!

Insane!

I found some mods and will test them soon, but there is no visible mem controller anywhere. Just PLL and core.

This thread is a bit quiet. Anyone have access to the VT235WF datasheet? I need it for memory voltage control on my GTX 260 216sp 65nm card. Thanks in advance. Edit: that's the mosfet apparently. (facepalm) It was the only thing which looked like a controller other than the VT1165 on core. But apparently this is the GTX 280 PCB and there is no visible mem controller.

Do bear in mind you might have to bin motherboards for ram clocking as the MC is in the NB (for 775). And at high volts (>2.6V, not sure) D9s can develop a weird volt-boot behaviour where they won't boot below ~2.4V (again not 100%). Edited to specify platform.

DDR2 D9s scale up to 3V in my experience (not tested higher as my board doesn't support it). Apparently it can CB/CBB at around -60/-50, as people with stronger phases have had issues compared to my testing.

Happy New Year!

Insane!

Merry Christmas guys!

Just 42 chips? WTF! I binned ~60 E2140 and highest I got was 470.

Cold PSC FTW!

Wrong thread. I think you mean for the CC.