Mr.Scott

Actually, they were the best s462 pi boards there was. Only bad about those boards was the 2v vcore limit. I still have one along with an Infinity Ultra, which is the same board without the LP bling.

Negative. It would still have be subbed as a Quadro, even modded. Run your GTS. It won't be much worse.

Good.

Use 890 boards for AM3.

Probably correct. Alpi is a straight shooter so I'm sure there was nothing underhanded going on.

Hey now.......... Better to be the bullet than the target.

Cutting the cartridge and opening the cartridge equals the same thing. Damaged factory packaging. Your point is irrelevant. You're just being difficult now.

Not sure about that particular board but, I disable boost.

That's a valid report though. Wrong category.

Offer is for life. Whenever you're ready.

Render is blocked. Cannot block ANY of render in any CineBench. Better to try to beat me benching rather than waste everybodys time reporting good subs.

Join us Havli. You know you are more than welcome.

840T is Zosma. http://www.cpu-world.com/CPUs/K10/AMD-Phenom II X4 840T - HD840TWFK4DGR.html Phenom II processors with Zosma core can be identified by: Part number: OEM part starts with "HD" and ends with "4DGR". An example: HD840TWFK4DGR. CPU ID: All Zosma-based processor have CPUID 100FA0. As a note, CPUs with Thuban core have the same CPUID. We can do pics of CPU's for verification if you like.

Abstained

Miss you George.

Screenshot is fine. Mods approved. You've already reported it 3 times. Don't do it again.

Taken care of I see. Sorry about that.

For the cartridge processors, pic of the case or the actual processor?

None from me.

Yes. Crashed upon start of bench. Couldn't get 3.2 anything to go right.

Gonna try 3.1.1 and see if I can get that to go. EDIT- 3.1.1 was straight forward and everything works. Thanks for trying to help me Yo-Yo.

Yes

Nope. Crashes when you try to save the file. The bench crashes upon start if you set anything but off.

Crashes on everything but 'off'.

OK, now that I'm using the correct 3.2 version, how the hell do you save the result file? Everything I've tried just closes the program and never saves the file.